Robert, just to be clear, you are indicating the old nut is on one side of the bike, and after inserting the new bolt, the new nut is now on the other side of the bike. Did I get that correct? Thanks for the help.
Dave
--- In st2_owners@yahoogroups.com, Robert McNabb wrote:
>
> Hey Dave, do the front bolt first, take the nut off and slide it back just a bit, slide new bolt in and use it to
>
> push the old one out. Tighten it up (I didn't do this step on my last change but it may help to stop the rear from
> sagging a bit as you repeat the process there.
> The rear bolt may require a slight tap, DO NOT use an 8lb sledge hammer. :)
>
> Â
> Robert McNabb
> Blue Ridge Mountains, Virginia
> 99 ST4 Red
> 2003 ST4s Red
> https://www.facebook.com/BlackHorseLogging
>
>
>
> ________________________________
>
| Reply via web post | Reply to sender | Reply to group | Start a New Topic | Messages in this topic (34) |
0 comments:
Post a Comment