Sounds like you got a wheel for an SS, at's 4mm narrower disk-sprocket.
I never did get around to figuring out on which side, though, I should
do that some time (I've got an SS 1000 and an ST2).
Tom
On 30-Nov-10 06:33, Lee wrote:
> liSTers, any of you change your 3 spokers (from ST4) to the 5 spoke Marchesinis , and did you use any different spacers.
> I have recently purchased a set from Italy, front fits fine, rear when fitting and before tighetning has more gap on the axle,and obviously would tighten using too much of the nuts on each side.
> I pulled it and measured as best i could and it appears the sprocket carrier needs to be spaced out another 5mm, this would need to be done where the carrier sits against the wheel where the cush drives are, bit funky for my liking , am i missing
From: T <st2_@ticino.com>
To: st2_owners <st2_owners@yahoogroups.com>
Sent: Tue, Nov 30, 2010 4:25 am
Subject: Re: [DucatiST] marchesini GAP
I never did get around to figuring out on which side, though, I should
do that some time (I've got an SS 1000 and an ST2).
Tom
On 30-Nov-10 06:33, Lee wrote:
> liSTers, any of you change your 3 spokers (from ST4) to the 5 spoke Marchesinis , and did you use any different spacers.
> I have recently purchased a set from Italy, front fits fine, rear when fitting and before tighetning has more gap on the axle,and obviously would tighten using too much of the nuts on each side.
> I pulled it and measured as best i could and it appears the sprocket carrier needs to be spaced out another 5mm, this would need to be done where the carrier sits against the wheel where the cush drives are, bit funky for my liking , am i missing something???, any help much appreciated, regards.lee ALMOST ready for a good ride in 4 days time
0 comments:
Post a Comment