you only need a bit that's half as long as the block is wide. taper bits should be enough, they have one for ~16 USD [not that I was looking yesterday, when my bolts arrived or anything]
From: Jack Ward <jaxn51@gmail.com>
To: st2_owners@yahoogroups.com
Sent: Wed, March 30, 2011 7:38:03 PM
Subject: Re: [DucatiST] Re: Engine mounting bolts
Wayne,
Do you have the bit for enlarging the openings? I looked on McMaster-Carr's site a couple of days ago and found a 12" bit for around $30. If you don't have one, then I'm going to post a notice and ask how many are doing this mod. Perhaps a few folks may want to combine finances and do a group purchase of the bit.
On Wed, Mar 30, 2011 at 4:27 PM, Nankervis, Wayne <WTNANKERVIS@bemis.com> wrote:
I'm attempting to start to install mine tonight. I will update my progress.Wayne'99ST2
--
Jack Ward
'00 ST4 Ducati (New Street)
'92 750ss Ducati (Restoration Project)
'63 H-D Panhead (Old Ratbike)
Now in Woodstock, GA, USA
__._,_.___
To unsubscribe from the list please send an email to: st2_owners-unsubscribe@yahoogroups.com
MARKETPLACE
.
__,_._,___
0 comments:
Post a Comment