Sorry, I'm at work and its at home. I could post the dimensions later if you want... Randy
On Tue, May 28, 2013 at 10:37 AM, Jerry Duke wrote:
Randy, You wouldn't have some dimensions on that would you?
Jerry
On Tue, May 28, 2013 at 1:26 PM, Randy & Tracy Dumont < rntdumont@charter.net> wrote:
I have cut a piece of plywood in the shape to slip in vertically between the back of the oil cooler and the front of the exhaust pipe. Covered with duct tape and jack against that. Works for an ST4s. Randy
On Tue, May 28, 2013 at 8:13 AM, Rich Goforth wrote:
Can you expand on "under the front exhast pipe" ? I am not sure where to place the jack.
On May 28, 2013 11:10 AM, < doghaus@rivernet.net> wrote:
A sissors jack under the front exhaust pipe, with the bike on the
center stand, or hang it from the ceiling.
Dave G
On Tue, 28 May 2013 14:54:43 -0000, "goforthnconquer"
< rcgoforth@gmail.com> wrote:
> What are some favored methods for supporting the front end off of the
> ground? I have the forks off for service, but I used a pitbull front
> stand for that, which seems to prevent me from replacing the bearings
> as that is where it is supporting the frame.
>
>
> --- In st2_owners@yahoogroups.com, nicktoh@... wrote:
>
>> Major operation. Must support front end off of ground, remove
>> bodywork, wheel, forks, triple trees, remove inner races, install
>> inner races, reinstall in reverse and torque everything to spec.
>
>
>
>
>
> ------------------------------------
>
> To unsubscribe from the list please send an email to:
> st2_owners-unsubscribe@yahoogroups.comYahoo! Groups Links
>
>
>
__._,_.___
| Reply via web post | Reply to sender | Reply to group | Start a New Topic | Messages in this topic (22) |
To unsubscribe from the list please send an email to: st2_owners-unsubscribe@yahoogroups.com
.
__,_._,___
0 comments:
Post a Comment