Sports: RE: [DucatiST] Steering Head Bearing Replacement

Thanks!

On May 28, 2013 9:44 PM, "Randy & Tracy" <rntdumont@charter.net> wrote:

Jerry,
Here ya go. This is for an ST4s but might work on all ST series…

½" plywood, cut 5-1/2" x 7-3/4"
Looking at the Front, Across the top (long way): 3-5/8" cut a 3/4" long by 1"deep notch. Move along another 2-1/8" and notch to the corner 1/2" deep.

I will try a crude sketch, I don't know how it will transfer but I used Arial font, size 11. Good luck. Randy

   3-5/8"       3/4"     2-1/8"    1-1/4"
__________        ________
|                   |      |                |_____

|                   |___|                           |
|                                                      |

|                                                      |
|                                                     |

|                                                     |
|___________________________|

From: st2_owners@yahoogroups.com [mailto:st2_owners@yahoogroups.com] On Behalf Of Jerry Duke
Sent: Tuesday, May 28, 2013 12:33 PM
To: st2_owners@yahoogroups.com
Subject: Re: [DucatiST] Steering Head Bearing Replacement

I would, thanks!