Matt,
My mistake. You are talking about this seal and needle bearing right?
http://ducatiforum.co.uk/f41/strange-oil-leak-749-a-5772/
I have never greased or replaced these items. Maybe the next time I am in there I better!!
seal: 93040491A
cage: 70250441A
Randy
On Tue, May 21, 2013 at 12:32 PM, Matt Rychtanek wrote:
Hi Randy,
The bearing I am talking about is the little needle bearing that is in the shaft that the pushrod goes through. LT's book shows him greasing it in a picture in the clutch maintenance section. I'm going from memory but I think it's picture 32
Sent from my iPhone
On May 21, 2013, at 11:58 AM, Randy & Tracy Dumont < rntdumont@charter.net> wrote:
I believe this is what I used from Ca-cycle works....
Your talking about the bearing that presses into the back of the pressure plate right?
Randy
On Tue, May 21, 2013 at 9:34 AM, M Rychtanek wrote:
Thanks Randy,
Yes, I's definitely prefer to replace it.
Does anyone have the PN or if there is a standard equivalent? I've looked through online parts fiche and I'm unsure what bearing it is. Most of them end at 2000 so maybe the design changed? The closest I can tell is the bearing is number 76270.0827 and the seal is 93783.0812 on the Gearbox page. Do these sound correct.
Matt
--- In st2_owners@yahoogroups.com, Randy & Tracy Ipad <rntdumont@...> wrote:
>
> Matt,
> I would just replace it for ~$18. You don't want it coming apart in the worst possible location, with no dealer around. Cheap insurance.
>
> Sent from my iPad
>
__._,_.___
| Reply via web post | Reply to sender | Reply to group | Start a New Topic | Messages in this topic (6) |
To unsubscribe from the list please send an email to: st2_owners-unsubscribe@yahoogroups.com
.
__,_._,___
0 comments:
Post a Comment