Sports: Re: [DucatiST] Re: Clutch Pushrod Needle Bearing.

Hi Randy,

The bearing I am talking about is the little needle bearing that is in the shaft that the pushrod goes through. LT's book shows him greasing it in a picture in the clutch maintenance section. I'm going from memory but I think it's picture 32

Sent from my iPhone

On May 21, 2013, at 11:58 AM, Randy & Tracy Dumont <rntdumont@charter.net> wrote:

I believe this is what I used from Ca-cycle works....

http://ca-cycleworks.com/6201

Your talking about the bearing that presses into the back of the pressure plate right?

Randy

On Tue, May 21, 2013 at 9:34 AM, M Rychtanek wrote:

Thanks Randy,

Yes, I's definitely prefer to replace it.

Does anyone have the PN or if there is a standard equivalent? I've looked through online parts fiche and I'm unsure what bearing it is. Most of them end at 2000 so maybe the design changed? The closest I can tell is the bearing is number 76270.0827 and the seal is 93783.0812 on the Gearbox page. Do these sound correct.

Matt
--- In st2_owners@yahoogroups.com, Randy & Tracy Ipad <rntdumont@...> wrote:
>
> Matt,
> I would just replace it for ~$18. You don't want it coming apart in the worst possible location, with no dealer around. Cheap insurance.
>
> Sent from my iPad
>